Power UNITS FOR LIFT TABLE 1
Basic Description
This power unit is designed exclusively for your tiny lift table,Consisting of substantial pressure gear pump, AC motor, multi-functional manifold, valves, tank, and so on. This electrical power unit continues to be widely used while in the field of logistic products for instance minifork lift, scissors lift and ariel doing work platforms. The lower-ing motion is controlled from the solenoid valve with the pace controlled through the adjustable needle valve.
Electrical power UNITS FOR LIFT TABLE two
Basic Description
This power unit is created exclusively for the medium lift table, Consisting of remarkably effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The decreasing movement is actived through the solenoid valve plus the speed controlled from the adjustable needle valve. Once the lift rises to a large positoin, but the electrical power supply is reduce, the decreasing motion is managed from the guide override function.
Energy UNITS FOR LIFT TABLE three
Basic Description
This power unit is designed exclusively for that huge lift table, Consisting of extremely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering movement is actived through the solenoid valve as well as pace controlled by a stress compensated movement handle valve.
Power UNITS FOR LIFT TABLE 4
Standard Description
This power unit is created solely for your significant lift table, Consisting of highly effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering movement is actived by the solenoid valve plus the velocity managed from the adjustable needle valve. Once the lift rises to a substantial positoin, but the power supply is cut, the lowering motion is managed from the manual override function.
Special Notes
1. This electrical power unit is of S3 duty cycle, which can only perform intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
two. Clean all of the hydraulic parts concerned ahead of installation of the energy unit.
three. Viscosity from the oil shoud be 15~46 cst,which need to also be clean and free of impurities.N46 hydraulic oil is advisable.
four. Oil modifying is needed following the initial one hundred operation hours,afterwards when each 3000 hours.
five. The energy unit proven is designed to be mounted vertically.